CAPS: All panels are capped along the top rail. All gates are capped on top and bottom rail. Our weldon caps prevent injury and enhance appearance.

CORNERS: Top corners are squared, not rounded or curved. This eliminates the chance that livestock may hang a leg in between panels where they are joined.

JOINTS: Joints are notched and welded all the way around for maximum strength and a smooth finish. This process eliminates moisture from penetrating rails and causing damage.

UPRIGHTS: Vertical uprights are built out of the same material as the rails - each upright goes clear to the ground for SUPERIOR SUPPORT. Uprights are spaced evenly throughout the panel, never going over 6' without a vertical upright.

CLAMPS: Panels are attached together with a galvanized panel clamp assembly that is included in the price of each panel. This system leaves only a 3/8" gap between panels. The rigidity of this clamp system also will not allow panels to move and rattle or clang when in use like a pin attachment or chain attachment system.

MATERIAL: Constructed of 15 gauge American-Made 1 - 5/8" OD round galvanized steel tubing. Tubing has a .072 wall thickness and a 65,000 lb yield strength. The rust-resistant finish will provide decades of use and retain its decorative silver appearance.

1 - 7/8" OD 15 gauge material available on special request.